SALUS RT310SPE Internet Wireless Thermostat Quick Guide

SALUS RT310SPE Internet Wireless Thermostat

Introduction

The RT310SPE module will switch your appliance on or off in accordance with the temperature set by you. The completed RT310SPE series consists of a transmitter – RT310TX thermostat and a Smart Plug SPE868.
Go to www.salus-manuals.com for the full PDF version of the manual.

Product Compliance

Directives: EMC 2014/30/EU, LVD 2014/35/EU, RED 2014/53/EU, and RoHS 2011/65/EU.
Full information is available on the website www.saluslegal.com

Safety Information

Use in accordance with national and EU regulations. Use the device as intended, keeping it in dry condition.
Product for indoor use only. Installation must be carried out by a qualified person in accordance with national and EU regulations.

Button Functions

1. Turn on the LCD backlight.
2. Turn On/Off the Frost Mode
3. Increase button.
4. Decrease button.
5. Test Mode/ Pairing Mode

LCD icons

1. The thermostat is calling for heat
2. The thermostat is in frost mode
3. The thermostat is sending a signal to the smart plug
4. The low battery indicator icon
5. Temperature display

DIP switch settings

The DIP Switches can be found on the rear of your thermostat.

Control feature	TPI	Span
Operation	When TPI is selected on DIP switch № 2, the DIP switch № 1 is functional. You can choose the Cycles Per Hour between a lower comfort level (6CPH) and a higher comfort level (9CPH).	When Span is selected on DIP switch № 2, the DIP switch № 1 is not functional. The temperature accuracy of your thermostat is set to ± 0.25 °C.

Smart plug LED indication

Installation

1. Installation – Step 1
   The thermostat and the smart plug are pre-paired from the factory if purchased as a pack. If not, follow the thermostat pairing process.
2. Installation – Step 2

Thermostat pairing process

• In case you have more than 1 smart plug, set ALL the smart plugs into pairing mode and start the pairing process. The LED will flash red when the plug is in pairing mode.
• Put the thermostat into pairing mode, by pressing the pair button for 3 seconds. After the smart plug is paired with the thermostat, the LED is steadily red.
• Begin pairing process
• End pairing proces

Test the pairing process

Change temperature

1. Actual room temperature
2. Setpoint temperature Note: By changing the Setpoint (desired) temperature, you are permanently altering your temperature.
3. Two seconds timeout
4. Actual room temperature

Frost Mode

Frostpoint review

Frost Protection Off

If the thermostat loses connection with the Smart Plug, the Smart Plug goes into fail safe mode after 22 minutes. In this mode you still can operate your Smart Plug manually (by pressing the button on the device).

Installer mode

Press the three buttons together for 3 seconds. Use to select dxx parameter, or to change parameter value and to confirm.

Parameter

dxx	Function	Parameter	Description	Default value
d01	Temperature display increments	0.1 or 0.5°C	Select temperature display increments	0.5°C
d02	Temperature offset	+/-3.0°C	Calibrate your thermostat temperature	0.0°C
d03	Frost setpoint	5.0-17.0°C	Set the Frost Point temperature	5.0°C

SALUS RT310SPE Internet Wireless Thermostat Quick Guide

The post SALUS RT310SPE Internet Wireless Thermostat Quick Guide appeared first on thermostat.guide.

source https://thermostat.guide/salus/salus-rt310spe-internet-wireless-thermostat-quick-guide/